Center punch tool is ideal for marking your metal for making holes.
- Ideal for closing rivets and eyelets
- Makes indents to help prevent drill bits from slipping while drilling
- Replaces worn dot/period stamps
- Easy to use!
Instructions:Work on a sturdy table and use a steel bench block or anvil under your pieces.
For Rivets And Eyelets: After making holes trough the items to be fastened together, layer them and insert a rivet through the holes with the flat head on whichever side you prefer. Lay the flat head of the rivet on your bench block then trim the straight end of the rivet so that it protrudes about 1/16" above the top layer of your piece. Position the pointed end of the punch on top of the rivet and use a hammer or mallet to strike the flat end of the punch with smooth, even force to flatten the rivet.
To Make Indents For Drilling:Position the pointed end of the punch where you want to drill a hole. Use a hammer or mallet to strike the flat end of the punch to create a small dimple in the metal. Position the drill bit in the dimple for drilling.
For Stamping:Same as drilling but will slightly less force when striking the punch.
Measurement & Specs
DIMENSIONS: 3.5 Inch Tall
SOLD: Sold Individually
MATERIAL: Steel
COLOR/PLATING: Silver
